Search
Use the search bar or filters below to find any TAPPI product or publication.
Filters
Content Type
Publications
Level of Knowledge
Collections
Journal articles
Magazine articles
Unlocking Product Potential with Renewable Nanomaterials, Paper360º March/April 2019
Unlocking Product Potential with Renewable Nanomaterials, Paper360º March/April 2019
Journal articles
Magazine articles
TAPPI News, Paper360º May/June 2018
TAPPI News, Paper360º May/June 2018
Journal articles
Magazine articles
Rice straw-based sustainable food packaging material with improved strength and barrier properties: Development and characterization, TAPPI Journal October 2023
ABSTRACT: Sustainable food packaging paper with high barrier and strength properties was developed with rice straw nanocellulose materials. Pulping and bleaching of rice straw were performed using an organosolv pulping and DED (D: chlorine dioxide bleaching; E: sodium hydroxide extraction) bleaching sequence. Bleached rice straw pulp was refined to 90°SR using a laboratory Valley beater. The laboratory handsheets were prepared using pulp slurry at 40°SR and 90°SR. The handsheets of cellulose nanofibrils (CNFs) made of highly refined pulp (90°SR) were surface sized using alkyl ketene dimer (AKD) wax to increase the barrier properties of paper for selective food packaging applications. The paper samples were tested for mechanical, optical, surface, and barrier properties, including tensile index, burst index, tearing index, bending stiffness, elongation, porosity, apparent density, opacity, Cobb value, water vapor transmission rate (WVTR), oil and grease resistance, and contact angle. The refined pulp (90°SR) was analyzed using field-emission scanning electron microscopy (FE-SEM), and it was observed that the morphology of the developed fibers changes to the nanoscale (<100 nm) for at least one dimension. The particle size distribution of the refined pulp using DLS analyzer also confirmed the cellulose fibers to near nanoscale. It was concluded that nanofibers were formed by a high degree of the mechanical pulp refining process and found to be much more economical than alternative processes in this direction. The sample handsheets of CNFs showed good strength and barrier properties. The barrier properties further increased when surface sizing was done using low-cost, nontoxic, and biodegradable AKD wax.
Journal articles
Magazine articles
Rheological behavior of magnetic pulp fiber suspensions, TAPPI Journal June 2021
ABSTRACT: This paper is focused on the rheology of magnetic pulp suspensions in absence and presence of an external magnetic field. Magnetic fibers were prepared by the lumen loading method using bleached eucalyptus fibers and cobalt ferrite (CoFe2O4) nanoparticles. The effect of mass consistency, temperature, concentration of magnetic fibers, and magnetic field strength on yield stress and apparent viscosity of the suspensions were investigated. In the absence of an applied field, a dependence of yield stress with consistency, as well as with the percentage of magnetic fibers present in the suspension, was found. In flow tests, all the suspensions exhibited shear-thinning behavior, showing that the viscosity is only affected by the consistency of the suspension. On the other hand, magnetorheological measurements show a negative effect of the applied magnetic field on the viscosity of the suspension.
Journal articles
Magazine articles
Investigation on the recycling of sulfuric acid from pretreatment of cellulose for nanocellulose preparation, TAPPI JOURNAL February 2020
ABSTRACT: Sulfuric acid is often used to pretreat cellulose prior to homogenization and conversion to nanocellulose. It would be economically significant to reuse the acid to close the overall value chain loop. The target of this work was to investigate the effect of recovery and recycling frequency of sulfuric acid from the pretreatments on the pretreatment yield of water-insoluble cellulose solid residue, and to explore the relationship between the nanocellulose size prepared by recovery of acid and number of cycles. The surface properties of the nanocelluloses were measured, including content of sulfate groups, absolute zeta potential, crystallinity, and thermal stability.
Journal articles
Magazine articles
Nanocellulose in Japan: An industrial perspective, TAPPI Journal April 2019
ABSTRACT: With the maturing of Japan’s economy, domestic demand for paper and paperboard is more likely to level off in the long term. Japanese paper companies are accelerating overseas production, especially in the emerging Asian markets, while strengthening competitiveness of domestic mills and developing new products. In Japan, we have always focused on emerging technologies and driving innovation in the pulp and paper industry. As a business definition, innovation does not equal innovative technology. Innovative technology can become innovation only when it is commercialized and used in industry.
Journal articles
Magazine articles
Paper coated with sonochemically synthesized zinc oxide nanoparticles: Enhancement of properties for preservation of documents, TAPPI JOURNAL January 2017
Paper coated with sonochemically synthesized zinc oxide nanoparticles: Enhancement of properties for preservation of documents, TAPPI JOURNAL January 2017
Magazine articles
Nanotechnology for Forest Products, PART 2, Solutions!, August 2005, Vol. 88(8) (408KB)
Nanotechnology for Forest Products, PART 2, Solutions!, August 2005, Vol. 88(8) (408KB)
Magazine articles
Nanotechnology conference targets research options, Solution
Nanotechnology conference targets research options, Solutions!, February 2005, Vol. 88(2) (117KB)
Magazine articles
Steam savings from nanochemistry, Solutions!, November 2004, Vol. 87(11) (130KB)
Steam savings from nanochemistry, Solutions!, November 2004, Vol. 87(11) (130KB)